Аз лично съм си програмирал ключовете за моят авенсис. В началото имах същият проблем. Стана след като изтрих запаметените трансспондери. Могат да се програмират 2 мастер и един валет ключ (мисля че един, не съм съвсем сигурен). Ето и процедурата по която си ги направих аз:YMR написа: ↑11 Ное 2018 14:31 Здравейте !
....
Според мен компютъра влиза в режим на програмиране ( след процедурата с 5 врътвания на ключа, 6 отв/затваряне на вратата и мастер ключ на Оn ), защото променя начина на мигане, но след едната минута излиза в стандартна позиция с премигване, като за непознат транспондер ( и за двете електроники ).
Някой има ли личен опит с този модел за тази ситуация и само посредством TechStreаma ли мога да програмирам транспондерите и с какви устройства и техните версии на Firmware и драйвер тази функция е достъпна ?
Има ли процедура за точно този модел за изтриване на запаметените транспондери ( без допълнителни уреди и програми ) и запаметяването на новите, и до колко броя могат да бъдат те ?
I Used this to erase the keys :
You can erase all the keys and start over by turning a working master key 6 times and then opening and closing the door 7 times. Then remove the key and reprogram again.
The master key that you use during this procedure obviously doesn't get deleted. (At least it didn't when I did it!).
Then this to add the new key :
"Programming New Keys"
STEPS:
1. Begin by sitting in the driver seat with all the doors shut.
2. Insert your working master (black) key in the ignition.
3. Very Quickly, turn the key from "LOCK" to "ON" 5 times. (You will end with the key in the "LOCK" position) [the 5 on-offs just need to be < 1 second each (you can hear something switching in the engine bay after 1 second switched to on - you've probably just got to beat that).]
4. Immediately, open and close the driver door 6 times very quickly. (End with the door closed)
5. Immediately, remove your working Master Key and insert your new Master Key
6. Turn the key to the "ON" position and leave it there while you wait for 1 minute.
7. After the minute, if you want to program another key, just remove the first one and insert the next one, turning it to "ON" and leaving it in position for 1 minute.
8. When you are through programming keys, just take the last one out, open and then close the driver door to lock in the programming, and your done.
Programming Sub Keys (Grey) is done the same way except you turn the master key 4 times before you open and close the door 5 times. Then insert the sub key, turn to the "ON" position, and wait your minute. Finish by removing the key and opening and closing the door 1 time as before. (лично при мен се получи се по процедурата с 5 завъртания и 6 отваряния но все пак го копирам както са го написали)